Stroking my 2010
Thread Starter
Joined: Jul 2003
Posts: 4,613
Likes: 0
From: Deer Park Tx
Stroking my 2010 New setup going into the 2010.
Should be fun to drive when I get it back.
Block was honed .010 with appropriate Torque Plates
Main bores where Line Honed with ARP Fasteners
416 built by Erik at HKE
11:1 Compression
Callies C-Series 4.000 crank
Callies Compstar 6.125 LS1 H-Beam rods W/ ARP2000 Rod Bolts
Wiseco 3cc Pistons 4.070 Bore
Federal Mogul 152M 3/4 Groove Main Bearings Coated
Wiseco GFX Piston Rings
ACL CB H-Rod Bearings for 2.100 SBC Chamfered Race Bearings Coated
ARP Main Studs
Balanced rotating assembly
Custom HKE cam 23X/24X, mid 600 lift I/E, 113+3 LSA
Harland Sharp Upgraded LS3 Rocker arms
Comp Cam Custom Pushrods
Melling LS1 HV Oil Pump
Double roller timing chain
LS7 HR lifters
Stock MAF
SLP Underdrive pulley
ARH 1 7/8 LTs into an ARH Catted X-Pipe, and Corsa Cat-Back
Roto Fab CAI
Should have it back sometime with-in a week.
just need to work on beefing up the rear..
It's going to be Sic
Should be fun to drive when I get it back.
Block was honed .010 with appropriate Torque Plates
Main bores where Line Honed with ARP Fasteners
416 built by Erik at HKE
11:1 Compression
Callies C-Series 4.000 crank
Callies Compstar 6.125 LS1 H-Beam rods W/ ARP2000 Rod Bolts
Wiseco 3cc Pistons 4.070 Bore
Federal Mogul 152M 3/4 Groove Main Bearings Coated
Wiseco GFX Piston Rings
ACL CB H-Rod Bearings for 2.100 SBC Chamfered Race Bearings Coated
ARP Main Studs
Balanced rotating assembly
Custom HKE cam 23X/24X, mid 600 lift I/E, 113+3 LSA
Harland Sharp Upgraded LS3 Rocker arms
Comp Cam Custom Pushrods
Melling LS1 HV Oil Pump
Double roller timing chain
LS7 HR lifters
Stock MAF
SLP Underdrive pulley
ARH 1 7/8 LTs into an ARH Catted X-Pipe, and Corsa Cat-Back
Roto Fab CAI
Should have it back sometime with-in a week.
just need to work on beefing up the rear..
It's going to be Sic
Thread Starter
Joined: Jul 2003
Posts: 4,613
Likes: 0
From: Deer Park Tx
