valve cover off
valve cover off I just pulled my driver side valve cover trying to find a tap that I've had with my stock rockers since the cheater cam install. How can I tell the rockers and rods are good? They all excetp 6 and 7 on the driver's side have very minimal side to side movement. 6 and 7 are pushed down and down have any play. Also what is the proper torque setting?
12 Second Club
Joined: Sep 2005
Posts: 689
Likes: 0
From: kentucky
do you just go one at a time at torque them down to 22ftlbs or any sequence you need to do i have a hard tappin after my cam install and still cant figure it out tried the 22ftlbs and still their just curios
On The Tree
Joined: Jan 2006
Posts: 190
Likes: 0
Do you know if you have the correct length pushrods? You must have properly sized pushrods, because a lot of times the base circle diameter of an aftermarket performance cam changes as compared to the stocker. Which is why they make tools like these.
http://www.lmperformance.com/6299/1.html
on pushrod length check
http://www.lmperformance.com/6299/1.html
on pushrod length check 
Originally Posted by thechef
22 ft/lbs is the tq setting
