Alternator Power Wire Problems!
Thread Starter
TECH Apprentice
iTrader: (6)
Joined: Sep 2007
Posts: 388
Likes: 0
From: Houston, Texas
Alternator Power Wire Problems! I am needing some help if possible. I just had my volt gauge drop last week and thought it may have been my brand new alternator and when I removed the 13mm power wire on top I noticed it easily just came out of the socket and was very brittle. I put a new piece on the end and put a lighter to the end to melt the plastic and its been at 14 volts ever since I fixed the problem. Today I left work and got into WOT and the gauge immediately dropped to 10 volts as it did before. I know it came loose again. So I know my problem but can anyone suggest any better methods of holding the wrap tighter once i clamp down on the wires? Here is a picture of the part I am speaking of. Thanks
http://i26.photobucket.com/albums/c1...Picture003.jpg
http://i26.photobucket.com/albums/c1...Picture003.jpg
11 Second Club
iTrader: (27)
Joined: May 2005
Posts: 6,799
Likes: 5
From: Your girl's back door giving her the long stroke while you're at work
Thread Starter
TECH Apprentice
iTrader: (6)
Joined: Sep 2007
Posts: 388
Likes: 0
From: Houston, Texas
