Now that I'm going back to regular exhaust.
Thread Starter
TECH Enthusiast
Joined: Jan 2008
Posts: 704
Likes: 0
From: Jupiter Floriduh
Now that I'm going back to regular exhaust. I've been having a problem keeping my ltft's in check due to the fact I have true duals. It should be easier to keep them in check now that I'm going back to normal exhaust right?
that doesnt hold water at all
if you want to go back to stock style exhaust thats fine but it wont help your fuel trims
you do know your fuel trims will never stay the same right?
Joined: Nov 2003
Posts: 6,216
Likes: 236
From: Wichita KS / Rancho San Diego
Long tubes are what gets your fuel trims messed up, not what's downstream from them. The location of the O2 sensors results in readings that are interpreted as lean conditions and the fuel trims are kicked up.
Trending Topics
Just get them as close as possible. Once you get them within 5% I would leave well enough alone. I try to get mine between 0 & -5 and then leave it alone.
You may go back a week later and fine tune it a little more but the fact is the only downside to them changing is throwing the wot fuel off, but if the trims are close then when it does change its not going to throw it off enough to amount to much.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
TECH Fanatic
Joined: Feb 2004
Posts: 1,259
Likes: 0
From: Lexington, KY
Basically you disable the fuel trims and tune your VE and maf (if your running one) tables to get your fueling in line. Without the fuel trims these tables need to be tuned very close and if so, your AFR will be right where it should be when the weather is about the same as it was when you tuned it. The downside is your 02's are then no longer keeping our AFR in line (via fuel trims) so it may run lean or rich depending on the weather. I'm using an EFI Live custom OS to address this, not sure if HP has something similar or not. With it you can adjust fueling depending on IAT temp. Seems to be working pretty good so far. I'm actually running speed density also.