porting/polishing FAST THROTTLE BODY?
Thread Starter
TECH Junkie
iTrader: (5)
Joined: Feb 2007
Posts: 3,183
Likes: 3
From: Key West, Florida
porting/polishing FAST THROTTLE BODY? got my FAST setup sitting here with the FAST 90mm TB.
the area just ahead of the blade has small ridges machined in it.
they are fairly smooth, but i'm wondering if there would be any real benefit from porting/polishing them smooth?
it would be one of those "can't hurt, every little bit helps" mods...
input?
the area just ahead of the blade has small ridges machined in it.
they are fairly smooth, but i'm wondering if there would be any real benefit from porting/polishing them smooth?
it would be one of those "can't hurt, every little bit helps" mods...
input?
