QTP headers question
Thread Starter
Staging Lane
Joined: Dec 2006
Posts: 60
Likes: 0
QTP headers question I have a 2000 Z28 and want to get headers for my car. I was looking at QTP headers because they are tuned and stainless. I was wondering how the fitment is with these headers and clearance issues. Also if anyone is using these headers with a quicktime bellhousing. Is there any modding needed to be done to the bellhousing?
i have qtps and like them alot. they dont hang low at all. the drivers side header was a little difficult to install but i think it was because i couldnt get the right angle and the car needed to be higher. def a nice set of headers.
I have both... The headers and the bell housing. I only had a slight issue where the "QTP" plaque was too close to the stearing linkage, too close for my likeing. But otherwise I have had no issues.
Launching!
Joined: Nov 2001
Posts: 280
Likes: 0
From: North Royalton, Ohio
Fitment is awesome. They were harder to install than the Pacesetter ones that I had before, but worth the effort. The driver's side header came with a hole in the collector in the middle of the four primary pipes that leaks/ticks, but I am dealing with it.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Five Reasons the Camaro Was the Most Pivotal Player in the Pony Car Wars 2.0
Brett Foote
10 Reasons the LS7 Is GM's Most Extreme Naturally Aspirated V8 Engine Ever
Verdad Gallardo
What does your car run NA? Is it stock heads and cam?
