HELP - 02 Wiring
HELP - 02 Wiring I just went to get my car tuned only to find out that my passanger side O2 wiring is burnt through. There is no signal from the O2 sensor. It is not the 02 sensor, but the wiring harness it connects to (which runs up beside the motor mount, and presumably to the PCM).
My question is: what is the most simple way to fix this?
Any help is greatly appreciated!
My question is: what is the most simple way to fix this?
Any help is greatly appreciated!
The simplest way to do it is cut out the burnt wires and but connect new wires in it's place. Be sure to use the same guage (thickness of wire). This is not ideal nor do I reccomend it but it's the easiest. Other than buying a new harness I would cut out the old wires and solder in new wires. Then cover the solder joints with heat shrink tubing for a water tight seal.
