Well I am finished with my 383 putting it all back in the car, noticed some oil in my ported fast 92, decided to pull it apart and clean it all up. I ordered the new ROPE seal from fast, and have been trying to get any help on how to re-assemble the three pieces. I sent an email no response, after 4 phone calls I finally got an email of a PDF file and the doofuss sent me the installation instructions of how to put it on the car You know the instructions that come with the intake, that I already have.
Where do you put the sealer, I know when I pulled the middle section off the bottom section there was some RTV around the ports, I am not so worried about the top section I assume just cut the rope seal to fit in all the channels, and put some (sensor safe) RTV where the ends meet up. The bottom is what has me wondering. Any help will be appreciated, Lord knows I have not had any luck with fast (comp) would figure they would give better tech help on a product that almost cost a grand.

 

got it all cleaned up, middle shell was definately put in to the lower with some RTV, I am guessing just lay a small bead in the lower half grooves around the ports where the middle section sits, and put some on the two holes that the screws from the bottom go into, and put the two pieces together and let them dry then put the top on?

 

Going to put it back together when I get home today, will gladly take advice from someone who knows.

 

I don't know but wish you luck...