weld in muffler

Reply Subscribe

Thread Tools

Search this Thread

May 4, 2010 | 04:24 PM

cgray305

Thread Starter

Teching In

Joined: Apr 2010

Posts: 6

Likes: 0

From: Bryan,TX

weld in muffler

I have a welded Flowmaster and want something different. I was thinking about just getting a 3 inch center inlet/outlet muffler, welding it in place of the Flowmaster, and having the exhaust out of the driver's side or a turn down before the rear bumper. Has anyone done this, is a good idea, or should i just spend the money on a catback?

May 4, 2010 | 08:09 PM

sixvi6-camaro

TECH Fanatic

iTrader: (9)

Joined: Dec 2004

Posts: 1,693

Likes: 0

From: Schaumburg, IL

Sure you can do it.. If its stock manifolds and cats I would cut it off and toss on a Flowmaster 1 chamber.

May 4, 2010 | 10:37 PM

cgray305

Thread Starter

Teching In

Joined: Apr 2010

Posts: 6

Likes: 0

From: Bryan,TX

the car has long tubes and off road y-pipe. just wanting something different and haven't seen anyone do the same.

May 4, 2010 | 10:47 PM

jsteele90

11 Second Club

iTrader: (13)

Joined: Mar 2007

Posts: 2,870

Likes: 2

From: delaware

same setup i have on mycar. i have long tubes, 3''high flow cats, 3'' y pipe, then a 3'' catback to a dynomax 3'' center inlet/outlet race muffler. then dumped right by the left of the bumper.