I just installed TSP 1-7/8 headers and a TSP catted y-pipe. The header/pipe on the driver's side is hitting the floorpan, but there's plenty of clearance on the passenger's side. Then I noticed that the engine is slightly higher on the driver's side than the passenger's side - like the engine rotated slightly from the torque reaction over time. Anyhow, I need to fix the problem. I figure new motor mounts are the solution. I'm figuring I'll use urethane mounts. Where can I get a set? Also, I'm not going to be able to raise the driver's side of the engine much, due to the exhaust clearance issue. Am I going to have to take the header off again to replace the mount on that side? Or has anyone replaced mounts with similar clearance issues?

 

 

not much room on my drivers side.....i have poly MM......the pass side has waaaaaay more room

 

Mine header/pipe is actually up against the floorpan.

 

my rubber mounts had shrunk...so the polys raised me a little