Best place for intake pipe?
Thread Starter
TECH Enthusiast
iTrader: (1)
Joined: Oct 2005
Posts: 587
Likes: 0
From: St. Cloud, MN
Best place for intake pipe? Where is the best place to buy supplies to make a custom intake inlet? Right now I have one, and it's make out of mild steel, so it's starting to rust on the inside of the pipe, and I'm worried about it flaking and being sucked into my blower. I would like to make it out of 304SS, but I could go aluminized steel as well. It doesn't need to be too long, just a straight section, to a 90* elbow, then down again. Also, it's a 3.5" inlet.
I get all of my tubing and fabrication material from Colombia mandrel bending, if you are looking for something larger like 4" to 6" then verocios motorsports and race parts solutions is the place to go. All of them will have the material at your door in 2 to 3 days. these are what most builders on here get their material from.
www.mandrelbends.com
www.verociousmotorsports.com
www.racepartsolutions.com
www.mandrelbends.com
www.verociousmotorsports.com
www.racepartsolutions.com
eBay.....why dont people know you can get ANYTHING on ebay by now.....
example...http://cgi.ebay.com/ebaymotors/UNIVE...item41526f13f5
example...http://cgi.ebay.com/ebaymotors/UNIVE...item41526f13f5
