Replacing alternator
Thread Starter
Joined: Mar 2003
Posts: 1,224
Likes: 2
From: Hamilton Ontario
Replacing alternator So I have a new 145 amp truck alternator to replace the stock alternator in the car, a 2001 camaro. I understand that there is a third bolt on the back of the alternator. I was under the car but couldn't feel where the third bolt is.
It's near the connector. A good 48t ratchet works AWESOME for putting this back in. A wrench should work for taking it out.
And this may help, grab a small socket to fit over the roll-pins and use a channel lock to pull them back out before re-installing the ALT or it will be a VERY tight fit. After moving the pins out with the channel locks, the alt will slight right into place.
Grabbed this pic from the other thread.
And this may help, grab a small socket to fit over the roll-pins and use a channel lock to pull them back out before re-installing the ALT or it will be a VERY tight fit. After moving the pins out with the channel locks, the alt will slight right into place.
Grabbed this pic from the other thread.
here is a pic from the drivers side right under the temp sensor.
http://i1239.photobucket.com/albums/...5/IMG_4167.jpg
http://i1239.photobucket.com/albums/...5/IMG_4167.jpg
Last edited by bayer-z28; Apr 11, 2011 at 09:24 PM.
