If you have the QTEC come in!
Thread Starter
12 Second Club
Joined: Dec 2002
Posts: 565
Likes: 0
From: SE Mass USA
If you have the QTEC come in! Well i got my unit today, though there is a problem that i didnt forsee. When I put the valve on the cutout, the wires dont stick out parallel to the cutout which would leave horrible ground clearance. I wanted to see how some of you have your in, and which way the valve sticks to give you ground clearance. I just want to know where to place the cutout when it goes in this week.
Thanks,
Mark
Thanks,
Mark
11 Second Club
Joined: Oct 2002
Posts: 1,400
Likes: 0
From: NY,CT & MA
look at their website...... here better yet look at this part of their website..
http://www.quicktimeperformance.com/...customers.html
it will give you an idea on how to setup... look at how the valve and cutout are place and have no clearance issues
http://www.quicktimeperformance.com/...customers.html
it will give you an idea on how to setup... look at how the valve and cutout are place and have no clearance issues
Thread Starter
12 Second Club
Joined: Dec 2002
Posts: 565
Likes: 0
From: SE Mass USA
Originally Posted by Durien
look at their website...... here better yet look at this part of their website..
http://www.quicktimeperformance.com/...customers.html
it will give you an idea on how to setup... look at how the valve and cutout are place and have no clearance issues
http://www.quicktimeperformance.com/...customers.html
it will give you an idea on how to setup... look at how the valve and cutout are place and have no clearance issues
It looks as though the cutout pipe should be level with the ground, and the valve should be angled up towards the floorboards. I just want to know where the fbody guys have them in the I pipe, and a good pic showing where the valve comes close to the floorboards.
Mark
