Fab VC and dipstick problem
#1
Fab VC and dipstick problem
Have fianlly got a very nice set of sheet metal valve cover, seem a lot taller than the stockers.
Problem lies with the dip is REALLY in the way, won't allow the cover to sit in the normal place good half inch to a inch off.
Was wondering what other people have been doing, I thin bending the dip stick that much it would snap the dip stick.
Problem lies with the dip is REALLY in the way, won't allow the cover to sit in the normal place good half inch to a inch off.
Was wondering what other people have been doing, I thin bending the dip stick that much it would snap the dip stick.