Clear Airlid, then SES?
Thread Starter
On The Tree
Joined: Nov 2003
Posts: 199
Likes: 0
From: SeaCoast NH
Clear Airlid, then SES? Did anyone else throw a code after the Airlid install? I didn't at first, but now I have one. Also installed a smooth bellows but that shouldn't make a difference, should it?
Was about to say the same 
Other than that, I have never heard of installing a lid and/or smooth bellows that would throw a code. Get it scanned before you do anything though, it could be anything, probably something not related to the lid/bellows at all
Other than that, I have never heard of installing a lid and/or smooth bellows that would throw a code. Get it scanned before you do anything though, it could be anything, probably something not related to the lid/bellows at all
Staging Lane
Joined: Dec 2003
Posts: 60
Likes: 0
From: Los Angeles
I threw an SES code when I did the FRA mod. Took it to the dealer and they said it was two air sensors or something like that. They replaced it under warranty. Maybe something similiar since both mods add more air to the engine. Good luck!
Bob
Bob
Could be the IAT, you may of damaged it. Check the other wires around there too. I did a spark plug wire change and got and SES code 15 miles later, turned out to be bad AIR valves, so the lesson is it may not have anything to do with the lid.
