Thoughts/opinions on system layout?
Thoughts/opinions on system layout? Been trying to make a duals system since February, and I've finally gotten everything together. Before I pull the trigger, I thought I'd post my system here so I could get some opinions on it, since I've never seen another f-body system routed like this before (or I'm not looking hard enough). It's an under axle system, 3" all the way through. The X is crush bent but everything else is mandrel. I still need a few inches of piping near the end but everything else major is taken care of. I'd much rather take some criticism than be driving a fireball down the freeway. Thanks! 
First of all ,not a fan or UTA . But if you're going to do it I would not use those mufflers . A better choice if you are going oval case is offset in , center out.By doing this you keep your X legs tighter and more parallel and better flow on muffler side too.
The front portion is good . Change the X to splayed on the inlet like you have it but parallel narrow on the outlet , then to the mufflers use offset in and center out. The mufflers inlets turned inboard toward the driveshaft.
