FAST intake swap- vacuum line question
Thread Starter
Staging Lane
iTrader: (2)
Joined: Jun 2006
Posts: 71
Likes: 0
From: Clarksburg, West Virginia
FAST intake swap- vacuum line question I have this vacuum line left over after a swap to a fast intake. I also removed AIR and EGR. I have a short line left over with a check valve and a T at the end. Is this line needed? I can't remember where it goes?
If you look into the engine harness on the passenger side near the rear of the intake you should see that platic piece that goes into there. Basically its fro a/c It goes into that t which gets connected to the intake and then to the air pump. Since you dont have air/egr toss that piece and just find the plastic one from your harness and connect it to the intake for your hvac controls to function
