MAF swap created P1514 Error
#1
MAF swap created P1514 Error
Looking for some words of advice here today. So this morning I went down to change my MAF in an effort to try and squelch a P0101 code
long store short, when I replaced it and buttoned everything up, the truck backfired and threw a P1514 when I went to start it.
the truck was running perfectly up until I swapped the MAF, now it doesn't run correctly regardless of which one is in there.
MAF is new
TAC / Throttle Body is Brand new
Map Sensor is new
Both 02 Sensors are new
what would cause this to happen over simply swapping a MAF???
long store short, when I replaced it and buttoned everything up, the truck backfired and threw a P1514 when I went to start it.
the truck was running perfectly up until I swapped the MAF, now it doesn't run correctly regardless of which one is in there.
MAF is new
TAC / Throttle Body is Brand new
Map Sensor is new
Both 02 Sensors are new
what would cause this to happen over simply swapping a MAF???
#2
TECH Senior Member
Was it running well with all the other new sensors installed? Or were they all installed at once, then it ran crappy?
#3
So i went out and started really picking around the engine compartment. Turns out that giant backfire through the intake was a lot more than a backfire. Now to figure out the WHY and which new intake I should get.
#4
TECH Senior Member
Yeah, that would lean out AFR a little.....