99 T/A replacing MAP sensor today
Thread Starter
On The Tree
Joined: Sep 2017
Posts: 186
Likes: 27
From: Pensacola, Florida
99 T/A replacing MAP sensor today Hows it going everyone. I'm going to replace my MAP sensor today, which means removing the intake. I was wondering if I should replace all the sensors that are hidden back there while I have the intake off? Is there anything else I should do while I'm back there as far as preventative maintenance?
TECH Senior Member
Joined: Jun 2016
Posts: 22,291
Likes: 3,616
From: Central Cal.
The only other sensors back there are the oil pressure sender and cam sensor.
The only other ones near there are the knock sensors under the intake manifold.
The only other ones near there are the knock sensors under the intake manifold.
Last edited by G Atsma; Aug 2, 2020 at 09:41 AM.
Thread Starter
On The Tree
Joined: Sep 2017
Posts: 186
Likes: 27
From: Pensacola, Florida
thanks for the heads up, I finally got the intake out and only broke the oil pressure sensor! I got the intake soaking in some dawn, my PCV hoses in the rear were trashed but I got a brand new one ready to install.The knock sensors look good so I'm gonna seal them up with some high temp. I hope this new map sensor makes my car start running again.
