catback sag?
Thread Starter
Joined: Jun 2005
Posts: 4,641
Likes: 392
From: cookeville, TN
catback sag? anyone ever had issues after installing a catback where the whole assembly titls down making the tips point at the pavement? Its a B&B tri flow system the outlets of the muffler are fixed 90 degree bends, and the issue seems to be at the inlet from over the axle. Im using the factory hangers so I know I could install more hangers closer to the tips if needed, but it doesnt matter how tight I clamp the over the axle pipe down after a few bumps the tips start to point down.
anyone else had this issue before?
anyone else had this issue before?
There are also 3 inch wide sleeve clamps with a step bent into them, to better seal over slip joints. I still did some work on mine to make them fit a little snugger, and used some sealant too for good measure.
