Another exhaust question.
Another exhaust question. Ok, so I bought TSP TD's from a local guy whom I believe is on here as well.
Basically I'm all for flow, so here's my question. He had flanges welded on where the dumps were to run pipes out the back. He has pipes to run out the back, but they are not mandrel bent.
I was wondering if that's gonna hurt he flow any. I figured it wouldn't considering it's not many bends and not very much piping.
Just wanting someone else's opinion.
Basically I'm all for flow, so here's my question. He had flanges welded on where the dumps were to run pipes out the back. He has pipes to run out the back, but they are not mandrel bent.
I was wondering if that's gonna hurt he flow any. I figured it wouldn't considering it's not many bends and not very much piping.
Just wanting someone else's opinion.
Well I mean I said I'm all about flow because I didn't want a whole system that was crushed bent that's why I bought the TSP system from him, but I figured those two tail pipes wouldn't matter because they're under the axle then exit...it's not like the whole system is crush bent.
