Sweet Thunders TD VIDEO
Thread Starter
Staging Lane
iTrader: (1)
Joined: Jan 2005
Posts: 89
Likes: 0
From: Savannah Ga and Orlando Fl
Sweet Thunders TD VIDEO Here is a video of Sweet Thunders VS Cutout
Burnouts, Donuts, in car.... from automatic to manual.
Hope this helps some of you guys find the sound you are looking for with you LS1's.
Click here to see Video
Burnouts, Donuts, in car.... from automatic to manual.
Hope this helps some of you guys find the sound you are looking for with you LS1's.
Click here to see Video Thread Starter
Staging Lane
iTrader: (1)
Joined: Jan 2005
Posts: 89
Likes: 0
From: Savannah Ga and Orlando Fl
It is actually the same two cars, just thru different stages of mods....
One is an M6 with a Lid/Cutout... The other used to be an a4 with lid/cutout...then it became the stalled a4 with the TSP X and sweet thunders.
One is an M6 with a Lid/Cutout... The other used to be an a4 with lid/cutout...then it became the stalled a4 with the TSP X and sweet thunders.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Get them and all the lost ground clearance will be worth it.
I don't think a YPipe can come close to the X's sound... But, seriously, you do lose ALOT of clearance and the lack of a nice torque arm selection kinda sucks...
I don't think a YPipe can come close to the X's sound... But, seriously, you do lose ALOT of clearance and the lack of a nice torque arm selection kinda sucks...
yeah lowered won't work. my car isn't gonna be lowered (one with the TS TD system in the video), but flipflop's will be so we are gonna have to figure out what we are gonna be doing with her exhaust.
TDs dont have to be lower than stock considering that you can tuck them tighter than stock and still not hit. I did mine and have no problem with clearance. I called lanes first for clearance numbers. I did about 3/8" to 1/2" on the drivers side and about 1/4" in the rear where the mufflers tuck into the tunnel. I have never hit any speed bumps or anything, and i think my clearance is as good as stock. Stock hangs pretty low on the drivers side.
I also have never hit the floor, even with 600 hp.
I also have never hit the floor, even with 600 hp.
