SDB

iTrader: (7)

Siliconed it .....TWICE....guess what....

I have seen some people bend a metal tab to secure it, but does anyone make a "part" specifically for this?

SDB

LawmanSS

iTrader: (19)

Sending PM...

TheBlurLS1

iTrader: (8)

Post up anything you find, i'll be doing the swap in a few days when my NW90 gets here and would really like to know myself. I plan on zip ties, lots of zip ties.

tails8

iTrader: (7)

Crazy glue worked for me. Be sure to let it dry before you install the intake..

Tails

WILWAXU

iTrader: (6)

To the top

topfig1

iTrader: (5)

No, I looked everywhere and could not find anything. take a hose clamp and cut a strip long enough to bend the bottom tab and drill it. Remove the bolt from the fast manifold directly below the map sensor and bolt the strip in place. Bend the to match the cotour of the intake. The map sensor has a slot on the outside. Slide the map sensor onto the metal strip and bend the tab forward slightly to hold it in place. You can put sensor safe silicone around the rubber of the map sensor if you wish before installing it. Hope this helps.

Fig