IAT mod question
Thread Starter
On The Tree
Joined: Sep 2002
Posts: 118
Likes: 0
From: Fort Worth, TX
IAT mod question I had question about whether to do the IAT timing tricker mod on
http://www.installuniversity.com/ or not.
Also, if to do it....should u do it with 4700ohm resistor or 8100ohm resisitor (SLP)?
Any comments are appreciated..my current mods are lid/filter/exhaust cutout.
Thanks,
Adnan K
http://www.installuniversity.com/ or not.
Also, if to do it....should u do it with 4700ohm resistor or 8100ohm resisitor (SLP)?
Any comments are appreciated..my current mods are lid/filter/exhaust cutout.
Thanks,
Adnan K
Re: IAT mod question Welcome to the board!
Here is an active post about the exact same subject:
https://ls1tech.com/ubb/ultimatebb.p...;f=24;t=003685
<small>[ October 02, 2002, 04:33 PM: Message edited by: WILWAXU ]</small>
Here is an active post about the exact same subject:
https://ls1tech.com/ubb/ultimatebb.p...;f=24;t=003685
<small>[ October 02, 2002, 04:33 PM: Message edited by: WILWAXU ]</small>
