Will X-pipe system fit w/spohn torque arm??
Thread Starter
TECH Junkie
iTrader: (71)
Joined: Mar 2002
Posts: 3,703
Likes: 0
From: East Brady, Pa
Will X-pipe system fit w/spohn torque arm?? I was thinking about getting an x-pipe true duals put on. After looking at pics I don't think it will clear my spohn torque arm. Anyone running this setup?
!Dial-up Director
Joined: Nov 2001
Posts: 3,100
Likes: 1
From: Louisiana
Re: Will X-pipe system fit w/spohn torque arm?? You can route it to clear the torque arm but you will lose a little ground clearence.
edit: I guess you are talking about where the crossover is located, if that is going to be a clearence issue? Does the shpoon arm mount in the stock location?
Justin
<small>[ October 10, 2002, 07:54 PM: Message edited by: Jsears8 ]</small>
edit: I guess you are talking about where the crossover is located, if that is going to be a clearence issue? Does the shpoon arm mount in the stock location?
Justin
<small>[ October 10, 2002, 07:54 PM: Message edited by: Jsears8 ]</small>
Re: Will X-pipe system fit w/spohn torque arm?? You should be able to fab it up in there. I have the BMR with the duals, and no problem, along with the driveshaft loop from Jegs. Works pretty good. I dont know the differences between the TQ arm you are talking of and the BMR, but you should be able to make it work. Good luck.
Thread Starter
TECH Junkie
iTrader: (71)
Joined: Mar 2002
Posts: 3,703
Likes: 0
From: East Brady, Pa
Re: Will X-pipe system fit w/spohn torque arm?? The spohn bolts on in place of the g load brace I think it is called. It hangs down a fair bit lower the the factory brace does.
