Bolting your headers to a custom Y-pipe / X-pipe?
Thread Starter
TECH Apprentice
Joined: Jan 2002
Posts: 337
Likes: 0
From: O'Fallon-MO.
Bolting your headers to a custom Y-pipe / X-pipe? I was told I need two 3" band clamps, one for each header,so i can bolt my headers to my x-pipe.And my x-pipe is 2.5" and the header collector is 3".
So i bought a 3"- 2.5" reducer,and it don't work.The reducer slips right over the collector.And the band clamp is a butt up design.So how are you guys doing this? I need a reducer that is 3" outside diameter to a 2.5".
Where can i get this type of reducer?I checked both jegs and summit, and all they have is 3" inside diameter for the slip on collector.
thanks
So i bought a 3"- 2.5" reducer,and it don't work.The reducer slips right over the collector.And the band clamp is a butt up design.So how are you guys doing this? I need a reducer that is 3" outside diameter to a 2.5".
Where can i get this type of reducer?I checked both jegs and summit, and all they have is 3" inside diameter for the slip on collector.
thanks
