Header install

Reply Subscribe

Thread Tools

Search this Thread

Jul 27, 2006 | 05:43 AM

scotts94_z28

Thread Starter

Launching!

Joined: Nov 2004

Posts: 297

Likes: 1

From: Rochester, NY

Header install

Ok im going to start my edelbrock long tube header install tommarow night and have searched but couldnt find any instructions. I dont really need them but it is always nice to have a guide so does anyone know where to find one? If not I only really need to know how to remove the dipstick?

Jul 27, 2006 | 06:04 AM

Juiced2000SS

TECH Fanatic

iTrader: (1)

Joined: Mar 2005

Posts: 1,237

Likes: 0

From: Fort Wayne, IN

Unbolt the dipstick from the head and pull it out. Easy as pie.

Jul 27, 2006 | 07:50 AM

Beasst8

TECH Fanatic

iTrader: (1)

Joined: Nov 2005

Posts: 1,142

Likes: 0

From: Goldsboro, NC

There is a bolt on the pass side head, un bolt it and pull. Like was said above, its easy as pie.

Jul 27, 2006 | 08:01 AM

V6 Bird

TECH Senior Member

iTrader: (15)

Joined: Nov 2001

Posts: 5,109

Likes: 0

From: Grand Prairie, TX

Quote:

Originally Posted by scotts94_z28

Unbolt the 15 mm bolt and pull it out. Before you take the manfiold off on that side. You will need to take the steering shaft out, the oil diverter plate off and then the header slides in on the drivers side if you have the car in the air high enough. No cutting off the ear on the block etc. Just remember. Believe 10% of the 80% of information people will post on here, and you'll come out smarter and with less headaches. LOL

Reply Subscribe

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Reply Share

First
Prev
1 / 1
Next
Last