Burst Panel ??
Thread Starter
11 Second Club
iTrader: (34)
Joined: Feb 2005
Posts: 3,158
Likes: 0
From: Ft. Wayne, Indiana
Burst Panel ?? Okay here's my problem.. I have Nitrous Burst panels installed in my FAST 90 intake but not running any Nitrous yet!!!.
I have had 2 panels blow on me ....not downward towards the motor but blown upward into the intake.
Has anyone else experienced something similar with these panels on a Naturally Aspirated Motor??
Any and all ideas/comments would be appreciated. Thanks
I have had 2 panels blow on me ....not downward towards the motor but blown upward into the intake.
Has anyone else experienced something similar with these panels on a Naturally Aspirated Motor??
Any and all ideas/comments would be appreciated. Thanks
Last edited by SS1875; Dec 7, 2006 at 06:12 PM.
Thread Starter
11 Second Club
iTrader: (34)
Joined: Feb 2005
Posts: 3,158
Likes: 0
From: Ft. Wayne, Indiana
Possibly but highly doubtful....they were installed by a very reputable engine builder . I replaced the first one that ruptured myself according to the manufacturer's instruction's and the cuurent panel in question was installed the same way.
The panel has already been removed so all pictures would show is the panel blown open.
Thanks for the reply
The panel has already been removed so all pictures would show is the panel blown open.
Thanks for the reply
Thread Starter
11 Second Club
iTrader: (34)
Joined: Feb 2005
Posts: 3,158
Likes: 0
From: Ft. Wayne, Indiana
Originally Posted by TheBlurLS1
That's strange. I've never seen one installed, much less blown. I'll copy this into the Nitrous forum, maby those guys can help you out.
Sounds good, thanks for the help I appreciate it.
