Which one???
Which one??? I am lookin to get headers for my Z28 $$$ does matter and dont which one to get. I am stuck between Hedman or pacesetter and dont know which is good.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Go Pacesetter. Flowtechs for third gens totally blew. Hedman's are very popular for them, but not so popular in the 4th gen crowd.
My coated Pacesetters had rusty water spots on them a few months after install, and they were not even driven on any snow/salt or through any big puddles. Go figure. If I had to do it all over again, I'd have just gone Kooks/QTP from the start.
My coated Pacesetters had rusty water spots on them a few months after install, and they were not even driven on any snow/salt or through any big puddles. Go figure. If I had to do it all over again, I'd have just gone Kooks/QTP from the start.