FAST Intake Warp
Thread Starter
TECH Senior Member
iTrader: (4)
Joined: Jul 2004
Posts: 8,092
Likes: 13
From: Little Rhody
FAST Intake Warp Been reading up on sealing the FAST intake and noticed a lot of old discussion (early 2005) about the FAST intake not sitting flat on the heads and as a result not sealing well. Is this issue corrected?
Seems to have been, I've never heard of a problem like that. Mine fits fine.
Some people have problems when they buy them used and don't replace the valley cover bolts, coolant tubes, or break the kock sensor wire clips off. There's 10 bolts holding that bitch down, so it should warp in your favor if there is a problem.
Some people have problems when they buy them used and don't replace the valley cover bolts, coolant tubes, or break the kock sensor wire clips off. There's 10 bolts holding that bitch down, so it should warp in your favor if there is a problem.
