1 Chamber question
Thread Starter
TECH Apprentice
iTrader: (7)
Joined: Nov 2005
Posts: 318
Likes: 0
From: Clearwater, FL
1 Chamber question I am getting ready to change the mufflers on my TSP true duals and am deciding to which size one chambers to go with. My idea is to buy the 2.5 inlet/outlet and cut the ends off and weld 3 inch pipe in. I noticed that the case size was 3 inch and I figure it is possible but am wondering if it has been done before? Or if anyone that has 2.5's thinks it is possible. I would go with the 3 inch inlet/outlet but i figure it would be nice to have a smaller case for clearance since I am lowered on Strano springs.
Thread Starter
TECH Apprentice
iTrader: (7)
Joined: Nov 2005
Posts: 318
Likes: 0
From: Clearwater, FL
Yeah I plan on adding pipe and doing some bending so I can swap in the flows or put the sweet thunders back on. So what your saying is that if I get the 2.5's the 3 inch pipe would be too big since the case is only 2.5?
Trending Topics
Originally Posted by LS69TA
I believe the cases are the same size on both the 2.5" inlet and the 3" inlet. I remember trying to find one with a thinner case back when I put the 1-chambers on my Camaro.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Thread Starter
TECH Apprentice
iTrader: (7)
Joined: Nov 2005
Posts: 318
Likes: 0
From: Clearwater, FL
Well I ordered the 1 chambers today and went with the 3 inch since I figured it would not make that big of a difference.
jmm98LS1 The case on the 2.5" in/out single chambers is 3" tall, but I don't see how you plan on sticking a 3" pipe into a 2.5" hole.
What I had planned on doing was cutting the tapper off where the 2.5's go from the case to the 2.5 and just welding the 3 inch pipe in there. I also heard your sound clip and that is what made me decide to go with the ASA and the 1 chambers instead for the torquer 3 I was set on. So thanks!
jmm98LS1 The case on the 2.5" in/out single chambers is 3" tall, but I don't see how you plan on sticking a 3" pipe into a 2.5" hole.
What I had planned on doing was cutting the tapper off where the 2.5's go from the case to the 2.5 and just welding the 3 inch pipe in there. I also heard your sound clip and that is what made me decide to go with the ASA and the 1 chambers instead for the torquer 3 I was set on. So thanks!