i need some help??
Thread Starter
Teching In
Joined: Mar 2002
Posts: 1
Likes: 0
i need some help?? ok, here is the problem, i keep blowing a fuse.. the fuse is the eng sen one.. in the manul it says that it is in control of heated oxygen sensor, maf, reverse lockout, cags.. well i sent my computer off and had the o2's, cags removed.. the car is all screwed up, it like takes off then starts shaking like the fuel is cut off and the backfires real bad.. the car drove for like a month with the new pcm in it.. so i dont think it is something that ed wright did.. the rpm needle doesnt even work i can be driving and it is sitting on 0.. then it starts working again then it stops.. i checked everywhere for a wire that could be arching.. the only thing i think might be the problem is that my battery hold down bracket was broke and i didnt know it.. when i would get on it the battery would fall back and arch against the a/c compressor.. i didnt figure that out for a while, i had just put a new cam in it and didnt know what was causing that.. so it actually arched probally 10 times before i fixed it.. so is it possible that the arching battery could have burnt something out?? any help would be greatly appreciated..
<small>[ March 26, 2002, 03:40 PM: Message edited by: 99huggerss ]</small>
<small>[ March 26, 2002, 03:40 PM: Message edited by: 99huggerss ]</small>
