90/90 Question
90/90 Question I know putting the FAST 90/90 is pointless for bolt ons but would it be worth it to put it on for say, a mild cam/heads setup? i tried searching but its been really buggy
if you are on stock cubes and your cam isn't over or close to .600 lift, you could spend your money elsewhere for more of a improvement.
a 90/90 won't hurt you on the top end- never seen someone lose power up top- but may take away from the low end if you go with a small H/C package.
If you get a great deal on the 90/90 then I would do it.
a 90/90 won't hurt you on the top end- never seen someone lose power up top- but may take away from the low end if you go with a small H/C package.
If you get a great deal on the 90/90 then I would do it.
On The Tree
Joined: May 2006
Posts: 141
Likes: 0
From: Fremont
you should do the same set up like mine. here look into this
https://ls1tech.com/forums/generation-iii-internal-engine/745616-dude-almost-done.html
https://ls1tech.com/forums/generation-iii-internal-engine/745616-dude-almost-done.html
With my mild H/C combo I picked up 14 rwhp and 10 rwtq though a 12 bolt. I think it was money well spent on my decision. Plus it'll be there when I rebuild.
Just for bolt on's though...probably not worth it.
Just for bolt on's though...probably not worth it.
