Which plug wires?...
Which plug wires?... Ok I had the MSD's for maybe a 1000 miles. One was sitting on the header and cooked it. I pulled the boot off of the wire. Granted its my fault the wire died but I really do not like how the MSD's go on. There hard to get to click into place.... sometimes you dont know if they did or not and the awkward positions you have to get into to try and get them to seat isnt fun. Any other good replacement wire that doesnt cost a billion bucks?
Thanks,
Erik
Thanks,
Erik
Originally Posted by RacerScott
I just put on MSD's tonight, everyone clicked into place and all were clearing the headers.
Maybe Ill just try em again and bend em off my headers The spark plug boot on the MSD wires is straight when you get them but they have a spot in the middle of them that is flexible so you can bend them to any angle you want to clear your headers. I have a set on my car and bent all of them were they don't come any where close to the headers.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
I didn't have any dielectric grease when I installed my MSD's, so I used a little spray silicone. I like them but I know what you mean about the engagement. It's tough to tell when they're fully in sometimes.
Got the new MSD's today. That was quick. thanks ws6store! Anyway the coil pack end looks like its been revised from my old ones. The internal metal has what looks like plastic around it. Im debating regapping the plugs. Im dreadin #8
i had the msd wires didnt care for the fit....I went with the crane cams spiral core 8.5 mm wires...very heat resistent wires...one of them has been against the pass side header since the headers went on in feb....it still looks good...ive had them on and off several times as well
i like msd wires why dont you just wrape you headers with that heat wrap stuff so you dont get to hot under the hood and you will not melt any more wires that would be the best bet epp sells the header wrap it works great
