01 ls6 intake ???

Reply Subscribe

Thread Tools

Search this Thread

Jul 28, 2007 | 06:48 PM

speedracer1280

Thread Starter

On The Tree

iTrader: (11)

Joined: Oct 2006

Posts: 128

Likes: 0

From: hattiesburg, ms

01 ls6 intake ???

will a 01 corvette ls6 intake have diff mounting since it has a wire tb...i would like to put put it on a 99 ta... would there be any problems???

Jul 28, 2007 | 09:47 PM

sroach20

TECH Addict

iTrader: (31)

Joined: Dec 2002

Posts: 2,318

Likes: 1

From: houston, Texas

it will bolt right in, just use your tb.

Jul 29, 2007 | 03:24 PM

speedracer1280

Thread Starter

On The Tree

iTrader: (11)

Joined: Oct 2006

Posts: 128

Likes: 0

From: hattiesburg, ms

I will be using my tb but my qestion is the throttle cable bracket mounts...since the vette was ETC...is there a boss drilled there are can i make it work??

Jul 29, 2007 | 03:31 PM

95 Z28

12 Second Club

iTrader: (21)

Joined: Apr 2006

Posts: 1,406

Likes: 0

From: West Seneca, NY

It'll bolt right up with no further modifications needed. Simply put the 3 bolts on that hold the TB on and you're all set. They type of throttle control doesn't matter.

Jul 29, 2007 | 03:37 PM

2xLS1

TECH Senior Member

iTrader: (25)

Joined: Nov 2001

Posts: 5,649

Likes: 9

From: Warr Acres, OK

Quote:

Originally Posted by speedracer1280

I will be using my tb but my qestion is the throttle cable bracket mounts...since the vette was ETC...is there a boss drilled there are can i make it work??

I have seen some that don't have the brass inserts for the throttle cable bracket and some that do. The holes will be there, but not always the brass inserts. You just need to look and see if that one has them.

Jul 29, 2007 | 05:01 PM

floman

10 Second Club

iTrader: (54)

Joined: Feb 2004

Posts: 621

Likes: 1

From: Bridge City,Tx

Quote:

Originally Posted by 2xLS1

Thats correct, there are some that dont have the threaded inserts. I dont remember the part# on the manifold, but I have had two or three of them. You can buy some nuts at a hardware store and thread them onto a long bolt and lock them together, then either machine them to the correct diameter on a lathe, or carefully grind them to the right size on a bench grinder and then press them into the holes. It works fine, does'nt take much to hold the cable bracket on tight. Good luck!

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last