Johns00Z28

iTrader: (6)

Hey I picked up a used SLP lid from a guy with a '98 LS1. I have a '00 LS1, is there going to be any compatibility issue or will it work? Thanks.
-John

matt94z

iTrader: (49)

same thing used from 98-00

Johns00Z28

iTrader: (6)

So they're the same lid? Cause I looked at lids online and I believe they sold 98/99's together and 00-02's together.

King Nothing

iTrader: (9)

i have a 2000 also, is there a hose inlet on your drivers side of the lid? other than that it should be the same

Johns00Z28

iTrader: (6)

I'll have to check and see if there's an inlet hose on the drivers side tomorrow. I'm also installing LT's w/ a catless y-pipe so I'm not sure if that makes any difference since I'm planning on getting rid of the AIR and EGR crap.

BigB02Z28

Not to hi-jack!

But what is that hose for?

I am... Erm... Was about to order a lid minutes ago, until I saw the difference in the years.

My car is a 2002, but I plan on deleting all the AIR stuff and such.

Also order will be w/ QTP race headers, if it matters.

Thanks,
Brandon

fast01z28

iTrader: (6)

that hose is for the AIR system, so if youre deleting it then get one without that connection. My GMS lid didnt have anything for the hose, i guess it came with a separate little filter.

King Nothing

iTrader: (9)

i'll take a pic in a little bit and show you what i put in place of that hose . . . as for that hose and every smog hose under my hood, there all in a box in the garage the engine bay looks less cluttered up
from what i've seen all SLP lid's have that inlet. don't forget SLP stans for StreetLegalPerformance, so some not all stuff with be 50 state legal

BigB02Z28

Thanks for the response!

So I guess since I am deleting that AIR stuff, I will be fine with a 98-99 lid. I was looking at the MTI clear lid, and the one without that inlet it nearly 20 dollars cheaper. Guess it will work for me!

TTT for OP

Thanks guys!