Wassup guys i got jet hot lt headers but i havent installed them yet. b4 i install them i wanted to weld on a reducer flange so i could bolt and unbolt true duals, well my question is will the flanged hit the floor board on the pass. side ive heard there preety close and if i put the flanged will it bang or is it alright? thanks in advanced

 

I hear flowmaster makes some type of
2 bolt flange that is very much like
what is on some stock exhaust.

I haven't seen them, just heard about it.
You might look into this, may help in
ground clearance and possibility of a
better seal? unsure though.

 

yeah you can go to summit racing, and I know they got them. I think their called Flowmaster ball-joint reducer. Good Luck

 

THANKS GUYS THAT WAS REALLY HELP FULL. GOT PART NUMBERS TOO FLO-15925 45.69 WAY BETTER THAN THE 3 BOLT FLANGED. GUYS IN LS1 TECH HAS BEEN REALLY HELPFUL SINCE I GOT MY CAR 3 MONTHS AGO. IM GLAD THERES THIS PALCE TO HELP ME CHOOSE THE RIGHT PARTS. THANKS GUYS