ryanfx

iTrader: (2)

I need something to use as a turn down at the end of an electric cutout - any ideas? I would like to make it not permanent (not welding pipe directly to the cutout) in case I need to send the cutout back or buy a new one. So some sort of bent pipe with a 3 bolt flange on the end.


something like this - any idea what I should order? I would prefer stainless.

CAMAROZ28AQUINO

i think borla or dynomax has some stainless turndowns u could make work with that.

ryanfx

iTrader: (2)

I was looking for something more like this but turned down (already flanged)

http://www.jegs.com/webapp/wcs/store...0002_199338_-1

chromeplated500

iTrader: (10)

It sure looks custom made. Ive never ran across anything like that but I have seen alot of custon stuff done like that using a purchased flange with the bolt pattern.

01 Red WS6

iTrader: (4)

I have one but it was custom made. Infact it was made at the same time my cutout was made from scrap we had left over

CAMAROZ28AQUINO

you could use that but its just a header reducer, it has no "turndown". You would have to weld an actual turndown to that to make it like that one in the pic you had

orangeapeel

iTrader: (18)

That looks like it would scrape like a ****. Not to mention the angles seem like they would be less functional for that purpose.

the underside of that car looks like someon either polished or sandblasted it. haha