Aftermarket returnless fuel rail set up?
Aftermarket returnless fuel rail set up? Any one running After market return less fuel rails , I want to get a set , i guess like the ones Nasty performance carries in polished-silver. More for looks.
But i want to find out if they can modded later and changed to be a return from them.
If anyone is using these can you let me know how you like them and how they installed .
Thank you
But i want to find out if they can modded later and changed to be a return from them.
If anyone is using these can you let me know how you like them and how they installed .
Thank you
People do this all the time...I'm still waiting on my FAST fuel rails (on backorder apparently), but all you do is make a cross-over at either the front or the rear, and cap one side of the other end off and use the other as the inlet. All you have to do to make it a return style setup is uncap it and run some more line.
I'm over-generalizing, but this stuff has been covered in detail in the fuel system section of this forum.
I'm over-generalizing, but this stuff has been covered in detail in the fuel system section of this forum.
No, it will not without an adapter. Most people swap it out for a braided stainless line (like me)...Russel and Aeromotive both make push connect fittings to adapt stainless braided line to the push connect fittings on the hard lines.
