LS6 CNC head flow chart
Thread Starter
Joined: Dec 2006
Posts: 848
Likes: 1
From: Crete, NE & Berthoud, CO
LS6 CNC head flow chart Dont know a whole lot about heads. found a set of CNC'd bare LS6 castings. this is the flow chart from them. the ports could use a little bit of polishing on them to help them out. Base on the chart, look like a good street head?
most cnc'd ls6 heads will be a good option. flow #'s are tough b/c they vary so much from bench to bench. lots of different ways to test them to show really high peak numbers. but it is a good way to get an idea for what you got.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo Thread Starter
Joined: Dec 2006
Posts: 848
Likes: 1
From: Crete, NE & Berthoud, CO
ahah no joke. another LS1tech'r found them on the net and sent me the link. I figured they were $400 ea....but when u get to the checkout screen, it says per pair. Maybe its a scam. I might try to buy them.
Thread Starter
Joined: Dec 2006
Posts: 848
Likes: 1
From: Crete, NE & Berthoud, CO
Ok, i just called the company and the heads are $400 each + 13.xx shipping per head. they are shipped bare. I about **** when it said per pair on there website....i would have been pissed when 1 head shows up.
Its never a bad idea to call and check. Saved you alot of hassle later on.
