Throttle Body outside diameter
#1
TECH Fanatic
Thread Starter
iTrader: (8)
Join Date: Jan 2003
Location: Maryland
Posts: 1,435
Likes: 0
Received 0 Likes
on
0 Posts
Throttle Body outside diameter
Hey guys just like the subject says how big around it the outside diameter of a stock 2001 LS1 throttle body??
I need to get a 90° bent rubber tube to go to my filter on my LS1 RX7 project car.
Thanks
Mike
I need to get a 90° bent rubber tube to go to my filter on my LS1 RX7 project car.
Thanks
Mike
#3
TECH Fanatic
Thread Starter
iTrader: (8)
Join Date: Jan 2003
Location: Maryland
Posts: 1,435
Likes: 0
Received 0 Likes
on
0 Posts
Re: Throttle Body outside diameter
Really I measured mine and it was 4". Then the MAF sensor fitting was 3.5"
Am I wrong??? 3" would be a lot easier to find stuff for it.
Am I wrong??? 3" would be a lot easier to find stuff for it.
#5
Restricted User
iTrader: (9)
Join Date: Sep 2002
Location: Sierra Vista, AZ
Posts: 7,603
Likes: 0
Received 0 Likes
on
0 Posts
Re: Throttle Body outside diameter
Well, I didnt say I measured it with rule or tape, but I KNOW A 3" x 3" Fernco WILL FIT nice and snug! Seeings how Fernco are not sold (not even sure if they are made in 1/2" increments) here except full inch sizes, and I do not need any clamps for mine, it must be 3" straight. Stretched? YEP.