Do you have to do this?
Do you have to do this? When I have replaced oil pressure sending units in the past, obviously you have to remove the intake manifold. Well the hardest part about the whole thing is those little pins that hold the electrical part of the fuel injector to the injector itself. My question is do you have to have these because last time I did it putting those in alone took me almost 2 hours and a lots of cuts and scrapes from the cowl. This time I said screw it and left them off. Do they absolutely have to be on there.
i think it is was locks the injectors wiring into it, i would keep them, if one slipped out or something that would be ****. They were hard for me too , but i just put some duck tape on my thumb and pushed as hard i as i could. worked for me haha 
All you got to do is buy you a thin walled sensor socket. They make a socket just for installing this. I got mine from the local NAPA and changed the oil sending unit out without removing anything else on the engine.
Trending Topics
You just have to push the clip in and pull up on the harness. Yes you to need to leave the clips or the connector could fall off while your driving. Yes it's pia for someone with popeye forearms. Welcome to the club of bleeding arms and hands.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
You should have stayed at the track last night and watched the pro mods. It was pretty cool being able to sit on the wall right beside them while they launch.
I only got to make 2 runs because of all the cars running the 1/8th. Damn 2 and a half hour wait for the second run.
