how is this suppose to work.

Reply Subscribe

Thread Tools

Search this Thread

Mar 29, 2008 | 02:52 PM

mtxfrk2k1

Thread Starter

Staging Lane

Joined: Feb 2008

Posts: 91

Likes: 0

how is this suppose to work.

i had everything off from TB out.

i got the MTI smooth bellow and Lid.

it came with the lid plus 1 rubber peice.

i put the smooth bellow on the TB and tightened it down.
put the MAF onto the other side of the smooth bellow and tightened it down.
so the other side of the MAF... does it go straight into the plastic of the LID?

the angle is so messed up i can not get it to fit.

Mar 29, 2008 | 02:57 PM

thebart455

TECH Apprentice

Joined: Oct 2007

Posts: 303

Likes: 0

From: eastern ky

my maf goes right into my lid on the front and bellow on the back. also it helps to use a blow dryer on the plasic back where the maf slides into, makes it slide in a whole lot easier!!!

Mar 29, 2008 | 09:49 PM

mtxfrk2k1

Thread Starter

Staging Lane

Joined: Feb 2008

Posts: 91

Likes: 0

it fits in fine if i have it off the car.. but the angle is what is messed up.. does it allow that 3" peice on the LId to bend downwards or what if i heat it up??