FAST 90 question
Thread Starter
Launching!
Joined: Feb 2004
Posts: 225
Likes: 3
From: Beavercreek, Ohio
FAST 90 question After installing my new FAST 90/90 setup I relized I didn't use the 2 pieces of foam on the bottom of the intake. 
Are they used to dampen intake sound from the KNOCK sensors?
Not that big a deal if I have to lift the intake and install them,
but I'd rather be modifying something else.
Are they used to dampen intake sound from the KNOCK sensors?
Not that big a deal if I have to lift the intake and install them,
but I'd rather be modifying something else.
Thread Starter
Launching!
Joined: Feb 2004
Posts: 225
Likes: 3
From: Beavercreek, Ohio
Well, I haven't driven yet as I need to get HPTuners hooked up and adjust my idle a bit I've noticed when reving the engine it has a louder and throatier sound even while idling around 950 rpm.
Man, I can't wait to drive with this new set up.
Anyone else?
Man, I can't wait to drive with this new set up.
Anyone else?
Thread Starter
Launching!
Joined: Feb 2004
Posts: 225
Likes: 3
From: Beavercreek, Ohio
Anyone else out there have an opinion?
This intake material seems to be thinner on the bottom of the lower portion than other areas. Are the knock sensors that sensitive or am I being paranoid?
This intake material seems to be thinner on the bottom of the lower portion than other areas. Are the knock sensors that sensitive or am I being paranoid?
