Balancer bolt Question
Thread Starter
TECH Apprentice
iTrader: (5)
Joined: Oct 2007
Posts: 359
Likes: 0
From: New Hampshire
Balancer bolt Question I have a new balancer bolt that I need to torque to the prescribed 37 Ft lb
than add the twist to (degree's). Need a pic of the graft that I could then cut out and use to over lay the balancer. Anyone have one from a GM service manual?? Thanks
Or should I just torque the thing to 40 ft lb's and call it a day
than add the twist to (degree's). Need a pic of the graft that I could then cut out and use to over lay the balancer. Anyone have one from a GM service manual?? Thanks
Or should I just torque the thing to 40 ft lb's and call it a day
Tq the bolt to 37 ft lbs. Get a sharpie and mark the bolt at 12:00. Make a mark on the pulley at 4:30. Turn the bolt until the marks line up. You will need to keep the crank from turning while doing this.
