Edelbrock LTs...
Thread Starter
Staging Lane
Joined: Feb 2003
Posts: 80
Likes: 0
From: Ft. Lauderdale, FL
Edelbrock LTs... Anyone hear anything much about these? I found Ramair 346 and Red12secZ28's posts about them, but was wondering if anyone else had any info. Last I heard, Edelbrock had stopped development to finish a BBC race header.
Any info on pricing and availibility? P/Ns?
Any info on pricing and availibility? P/Ns?
Re: Edelbrock LTs... Has anyone heard anything about the ground clearence and y-pipe for this setup....thinking about this...but not sure if you G2 springs are gonna make the car to low! TIA!!!
TECH Enthusiast
Joined: Feb 2002
Posts: 540
Likes: 0
From: Native Texan
Re: Edelbrock LTs... As far as a Y pipe you could use a Hooker Y with a 3.5 to 3 in transition, but the hooker Y actually necks down to 2.75. You could go to a muffler shop have them cut off the part of the Hooker Y that is 2.75 and have them weld on a piece of 3 inch pipe. Then like I said you could have them use a 3.5 to 3 inch transition. The Edelbrock headers are the same design as the Hooker/Jet-Hot but are a stepped 1-3/4 to 1-7/78 with a 3.5 inch merge collector. If you are stock cubes you could actually lose power by going to these headers unless your combo is really stout and matches the merge collectors perfectly. Merge Collectors are not something that are to be added just because. They need to have the size and length of the merge matched to the engine and most of the time it takes trail and error to find the correct collector.
