thought i would just throw some pics up ill keep pics updated as the build keep going

forged 347 with advance induction ported 241's and camshaft

 

nice job, love the guy with the Z28 shirt!!

 

So why did it come out? Freshening it up or stroking it, pistons maybe...It let loose.

 

asdsadfas

 

gorgeous

 

Sounds like a plan.. Did your lifter come apart? I have seen collapsed ones but never scattered. Roller tip rockers make a terrible mess in an engine have seen that a few times.

 

when i was rotating the assembly taking the pressure plate off you could hear metal pieces rolling around in the oil pan lol

 

wasnt as bad as i thought it was gonna be pulling it out of the top

 

 

wait you get to wear shorts? it's 3 degrees out and we've had snow on the ground since december 10th ish

 

haha charleston south carolina

 

Looks good. I would have gone out the bottom tho. Once you do it that way you will never even think about going out the top again IMO.

 

it only took two hours to get it out of the top

 

lol, the guy in the Z28 shirt- " Man, I don't think were going to be able to get this ****** high enough to get out."

 

haha we got it high enough, just my hand scraping the concrete to keep the tail shaft from hitting and blood everywhere lol

 

Just wondering, why did you pull the tranny also?

 

x2


2 hours removing the heads,powersteering, a/c, headers and all?

 

well orignally i was gonna pull the heads put new lifters in but that changed i decided to build it, by the time i had everything off. But if i knew i was building from the start i def would would have dropped the bottom. I pulled the tranny cause i need a new clutch anyways