Im trying to pull my balancer and damn it i cant figure out what size threads are in the balancer I was planing on using a 3 arm puller but you cant use it with the slp they do have three threaded holes... Does anybody know what size they are??/

 

i dont know the size but its in this kit, i know bc i checked it before i installed mine.......or call SLP

http://www.harborfreight.com/cpi/cta...emnumber=37824

 

just go to the autozone or advanced auto and rent the puller that has the bolts in it it has bolts that fitwith that piece that looks like a 'Y" ...but if u dont want to u can use the 3 arm puller but be careful it just about slips over the pulley ive done both and both work

 

Ive got a matco puller set Its in a vette and i left the radiator in just dropped the rack and i just cant get down in there to see very well.. Wasnt sure if they are metric or standard

 

SLP couldn't tell me, Snap-On and Mac sets don't have the bolts. Had to buy bolts and put them in kit. I have to go to my shop later and will see if I can get a size.

 

do you not have harbor freight close to you??????? i promise they are in this ten dollar kit...