torquer 2 ok with stock 243's?
Thread Starter
Launching!
iTrader: (2)
Joined: Apr 2007
Posts: 234
Likes: 0
From: lewisburg, pennsylvania
torquer 2 ok with stock 243's? i was originally going to go with a tsp heads/cam package(5.3's or ls6's), but due to my shrinking budget, i was thinking bout buying a set of used stock used 243's. i'm planning on getting the supporting hardware(pr's, springs, lifters, trays), but i wanted to know if the tsp torquer2(232/234, 595/598) will work well with these heads? plan on being a semi dd, hoping to put down 410-420 rwhp, and around 390-400 rwtq. any opinions/help/suggestions would be appreciated.
I put down 415 cam only with that cam through a M6 on my 02 Z. I am currently installing this cam on my 02 T/A which is a stalled auto. So i will see what that does. But a rear gear is a must with the M6, if not you will be a dog till 3500 RPM's.
Thread Starter
Launching!
iTrader: (2)
Joined: Apr 2007
Posts: 234
Likes: 0
From: lewisburg, pennsylvania
btw, bout how much does it cost to have the heads milled, ported, and polished? just in case i run into a little bit more money
We have a few sets of cnc ported 241 heads available for pretty reasonable. I think we have 3 sets we're going to be offering for $900 with beehives installed!!!
__________________
Jason
Co-Owner, Texas Speed & Performance, Ltd.
2005 Twin Turbo C6
404cid Stroker, 67mm Twins
994rwhp/902lb ft @ 22 psi (mustang dyno) www.Texas-Speed.com
Jason
Co-Owner, Texas Speed & Performance, Ltd.
2005 Twin Turbo C6
404cid Stroker, 67mm Twins
994rwhp/902lb ft @ 22 psi (mustang dyno) www.Texas-Speed.com
