Pushrod Length Setup
Pushrod Length Setup This isnt a question just a post. Showing the importance of measuring for pushrod length when setting up....add your setup and lenghts if you wish.
Stock Push rod is 7.4
My Setup
98 Block, Stock bottom end with stock pistons.
243 Heads Stage 2 CNC by TEA 61cc chambers, Caddy Race lifters
GM MLS head Gasket, ARP Head Bolts
Harland Sharp 1.8 rockers
Comp Cam 224 230 XE-R (Their Lift Number with stock: Intake: .581 EX: .588....I think their number is wrong it should be .591 on ex)......but with 1.8 its is Int .651 ex .626
Pushrod Length needed for .065 Preload.......
7.350
Stock Push rod is 7.4
My Setup
98 Block, Stock bottom end with stock pistons.
243 Heads Stage 2 CNC by TEA 61cc chambers, Caddy Race lifters
GM MLS head Gasket, ARP Head Bolts
Harland Sharp 1.8 rockers
Comp Cam 224 230 XE-R (Their Lift Number with stock: Intake: .581 EX: .588....I think their number is wrong it should be .591 on ex)......but with 1.8 its is Int .651 ex .626
Pushrod Length needed for .065 Preload.......
7.350
Last edited by bigboykilroy; May 6, 2009 at 11:15 AM.
